Tips on installing the H1000 DIN rail device with 12AWG wire

The terminal block used in the H1000 is spec’d to 12 AWG and our Engineering department tested with 12 AWG wire as well.  It can certainly be tight fit, but often times screw terminals are designed that way to ensure no over cabling.  

 

Here is an easy guide for installing this device:

  1. Trim the insulation of the wire to about ¼”
  2. Insert the wire into the terminal block
  3. DO NOT TWIST THE COPPER WIRE as it will be much more difficult to insert

Still having issues installing your H1000?

Please submit a support ticket so that we can put you in touch with an engineer to assist in troubleshooting.

 

Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.